Romeo V2-ALL In One Controller
Introduction Ro Meo V2[R3]is an All-in-One Arduino compatible microcontroller especially created for robotics applications from DFRobot. Specification DC Supply:USB Powered or External 6V~23V DC DC Output:5V (2A) / 3. 3V DC Motor driver Continuous Output Current:2A Microcontroller:ATmega32u4 Bootloader: Arduino Leonardo Compatible with the Arduino R3 pin mapping Analog Inputs: A0-A5, A6 - A11 (on digital pins 4, 6, 8, 9, 10, and 12) PWM: 3, 5, 6, 9, 10, 11, and 13. Please select Arduino Leonardo board when using Arduino IDE. 1 Wide operating input voltage Directly help Xbee and XBee form factor wifi,bluetooth and RF modules ON/OFF switch to manage the system power from extermal motor power 3 Digital I/O extension (D14-D16) S1-S5 switch replace jump cap Micro USB instead of A-B USB connector Analog sensor extension port: Orange for Signal,Red for Vcc,Black for GND The integrated 2 way DC motor driver and Xbee socket allows you to start your project immediatly with no the require for an additional motor driver or wirless shield. The Romeo benefits from the Arduino open supply platform, it is supported by thousands of open supply codes, and can very easily be expanded with Arduino Shields. Warning:The analog sensor port pin mapping on Ro Meo v2 is different from the old version. Provide 8-bit PWM output 5 crucial inputs for testing Auto sensing/switching external power input Serial Interface - TTL Level - USB Support Male and Female Pin Header Built-in Xbee socket Integrated sockets for APC220 RF Module and DF-Bluetooth Module Three I2C/TWI Interface Pin Sets (two 90° pin headers) Two way Motor Driver with 2A maximum current Improvement compared with Romeo v1.
© 2019 By Raid Controler Cards - All Rights Reserved.